Roll over image to zoom in
Venus GX Victron Energy internet-connected power system monitoring controller Venus GX
Victron Energy - BPP900400100
New product
Description and specifications
- This is a monitoring controller for Victron electrical systems.
- Parameter reading can be done from the free VRM website for remote monitoring.
- It has a customisable start/stop system.
- You can configure the state of charge, voltage, load, off-peak times and monthly test runs.
- Once connected to the internet all data is sent to the VRM.
- If there is no internet connection, the Venus GX will store the data for 48 hours.
- Allows a micro SD card or USB memory stick to increase data storage capacity.
- Data can be converted offline with the Victron Connect App.
- Internet connection can be made with an Ethernet cable via wifi.
- Updates automatically if a software version is available (when connected to the internet).
- It has an integrated Linux Venus OS operating system.
- The fuel tank level inputs are resistive, so they must be connected to a resistive tank level transmitter.
- Note: Victron does not supply such transmitters.
- The tank level ports can be configured for compatibility with European tank level transmitters (0 - 180 Ohm).
- Power supply voltage range is 8 - 70 Vdc.
- Current consumption of 210 mA at 12 V, 110 mA at 24 V and 60 mA at 48 V.
- With two isolated VE.Direct ports.
- With two VE.Can ports with isolated parallel RJ45 sockets.
- 2nd CAN interface non-isolated.
- With two VE.Bus ports with parallel and isolated RJ45 sockets.
- With two non-isolated USB host ports.
- With one RJ 45 socket for 10 / 100 / 1000 MB.
- It measures 143 mm wide, 45 mm high and 96 mm deep.
- Operates in temperatures from -20 to 50 ºC.
- Safety standard of EN 60950-1:2005+A1:2009+A2:2013.
- Compatibilities:
- Multiplus and Quattros inverters (including three-phase and split-phase systems).
- EasySolar 1600 VA.
- BlueSolar MPPT solar chargers with VE.Direct port.
- BlueSolar MPPT 150/70 and MPPT 150/85 with VE.Can port.
- SmartSolar MPPT 150/70 and MPPT 150/100 with VE.Can port.
- BMV-700 family that can be connected to the VE.Direct ports of the Venus GX.
- BMV-600 family that can be connected to the VE.Direct ports of the Venus GX.
- Lynx Ion plus shunt.
- Lynx Ion BMS.
- Lynx VE.Can shunt.
- Skylla TG battery chargers.
- NMEA2000 tank sensors.
- Fronius PV inverters.
- Allows connection of a USB GPS to the USB port. This will send the data to the VRM Portal for tracking. The map on the VRM will indicate the last position.