Up to 100 A smart management system for 12 V LiFePO4 smart batteries Smart BMS CL Victron Energy

Product description:

• This is a management system for Victron lithium iron phosphate (LiFePO4) smart batteries.
• It is designed for 12V systems with 12V alternator.
• It controls and protects all battery cells.
• In case of low or high battery voltage or over-temperature, it will disconnect the alternator.
• With reserved connection for the alternator, providing current limitation and unidirectional traffic from the alternator to the battery.
  • Any size alternator can be connected to the battery or Smart lithium batteries.
• The connection reserved for charging will disconnect the loads in the event of low or high battery voltage or over-temperature.
• Features a remote on/off connector.
• Protects the starter battery.
  • Current will only reach the LiFePO4 (LFP) battery if the input voltage exceeds 13V.
  • Current will not flow back from the LFP battery to the starter battery.
• The input current is electronically limited to approx. 90% of the nominal value of the fuse being used.
• Input overvoltages are regulated to a safe level, including transients.
• It will stop the charging process if there is over-voltage or over-temperature of the cells.
• It has three outputs:
  • Load disconnection output; in case there are cells that are going to have an imminent low voltage, it will switch to free-float.
    • Maximum current of 10 mA.
  • Pre-alarm output.
    • Can be used as a warning when the battery voltage is low.
    • To activate a relay, an LED or an acoustic signal.
    • This output is usually free-floating, it goes high in case there are cells that are going to have a low voltage. The delay between pre-alarm and load disconnection is thirty seconds.
    • Maximum current of 1 A.
  • Charger disconnection output; becomes floating when there is over-voltage or over-temperature in the cells.
    • Maximum current of 10 mA.
• It has MOSFET switches, making it fireproof.
• The maximum continuous load current is 100 A (with a 125 A fuse).
• The input voltage to start charging is > 13V.
• Excluding the charging and charger output current, the current consumption is 16 mA.
• Working temperature range from -40 to 60 ºC.
• It has IP65 degree of protection.
• The DC power supply connections are M8.
• The battery negative of the DC connector is a 6.3 mm female faston.
• Its measurements are 120 mm wide, 65 mm high and 224 mm deep.
• It weighs 1.6 kg.
• Emissions EN 61000-6-3, EN 55014-1.

Optional:

• Connection cable for BMS CL 12 V and 100 A.
  • This is a cable that connects a BMS (Battery Management System) without VE.Bus port and a MultiPlus model inverter.
  • It will shut down the Multiplus when the BMS encounters low or high voltage or high temperature alarm conditions on the Victron Energy "Smart Battery" (LiFePO4) battery bank.
  • Then, when the alarm condition disappears, the BMS will turn the MultiPlus back on.
  • This cable is compatible with the following models:
    • MultiPlus 500 VA and 1600 VA.
    • MultiPlus Compact 800 VA and 2 kVA.
    • MultiPlus-II with BMS products without VE.Bus interface.
      • For example Smart BMS CL 12-100 and smallBMS.
  • The cable must be connected to the on/off connector of the MultiPlus models.

Options to choose from::