Hover over the image to zoom in
DC DC step up power converter module MOSFET CC CV 400 W 25 A 12 24 V 50 x 60 mm for 3D printers Rosfix
Brand: Rosfix - S6KE-UIK7
Sold by: Habitium
At Habitium, all orders are sold and managed directly by us, so you will never have to deal with third-party sellers.
Product details
- Power: This 400 W DC DC CC CV step up voltage converter module is designed to improve the power supply circuit in 3D printers, providing a maximum output of approximately 400 W depending on the input voltage.
- Operating voltage: It operates from 12 V DC to 24 V DC and is compatible with various standard power supplies used in 3D printers and similar electronic systems.
Payment methods and financing
Ask a question about this product
Average response time: 4 working hours
Product details - DC DC step up power converter module MOSFET CC CV 400 W 25 A 12 24 V 50 x 60 mm for 3D printers Rosfix
- Power: This 400 W DC DC CC CV step up voltage converter module is designed to improve the power supply circuit in 3D printers, providing a maximum output of approximately 400 W depending on the input voltage.
- Operating voltage: It operates from 12 V DC to 24 V DC and is compatible with various standard power supplies used in 3D printers and similar electronic systems.
- Current: The nominal continuous current is 25 A, with support for up to 30 A to provide a stable and safe supply for filament heaters and heated beds.
- PWM signal amplification: PWM amplification enables precise and stable control of the heating system, improving response and energy efficiency.
- Galvanic isolation: An optocoupler electrically separates the control signal from the power section, protecting the control electronics and increasing system safety and reliability.
- MOSFET switching: High-performance electronic MOSFET switching reduces the load on the control board, relieving the power supply circuit and helping to prevent overheating or premature failures.
- Dimensions: The compact 50 mm x 60 mm format makes installation easier in electronic panels and confined spaces inside 3D printers or DIY projects.
- Compatibility: It is compatible with RepRap type 3D printers and RAMPS control boards, as well as popular models such as the Anet A2, Anet A6 and Anet A8.
- Recommended use: It is suitable for reinforcing the power supply circuit for the filament heater and heated bed, helping to maintain stable currents and consistent temperatures during 3D printing.
- Package contents: The package includes one 400 W MOSFET step up module, one approximately 15 cm connection cable and brief technical documentation to assist with installation and use.
SKU: 5905954111084, S6KE-UIK7