12V 3000 VA smart power inverter made of steel with blue and black finish Phoenix Smart Victron Energy

Product description:

• This is a pure wave smart power inverter.
• It has built-in bluetooth which can configure, with tablet or smartphone, the following functions:
  • Low battery voltage alarm.
  • Low voltage disconnection and restart level.
  • Load-dependent switch-off level.
  • Output voltage between 210 and 245 V.
  • Frequency 50 or 60 Hz.
  • ECO mode on/off and ECO mode level sensor.
  • Alarm relay.
• In addition, input and output voltage monitoring, load and alarms can be configured.
• It has a high starting power.
• It is short-circuit proof and protected against overheating.
• It has a VE.Direct port that can be connected to a computer.
  • A VE.Direct to USB interface cable is required.
• ECO mode allows the inverter to go into standby when the load drops below a preset value (minimum load is 15 W).
  • Once in standby, the inverter will be activated intermittently every certain configurable number of seconds.
    • The default time is every 2.5 seconds.
    • If the default level is exceeded, the inverter will remain in standby.
• Allows connection of a remote on/off switch or relay.
  • Can be connected to a two-phase connector.
  • The left terminal of the two-phase connector can be switched to the negative of the battery (or to a vehicle chassis).
• Operates in temperatures between -40 and 65 °C.
• It is made of steel with a blue and black finish.
• Its dimensions are 285 mm wide, 533 mm high and 150 mm deep.
• Its nominal voltage is 12 V.
• The apparent power is 3000 VA (volt-amperes).
• Its peak power is 6000 W.
• Its input voltage range is 9.5 to 17 / 18.6 to 34 / 37.2 to 68 Vdc.
• Its output voltage is 230 Vac.
• It has IP21 protection.
• Weighs 19 kg.
• Type A and G electrical protection.
• Safety standard: EN 60335-1.
• Includes 1.5 m battery cable.
• Easy to assemble.