Electric water heater with 50 litre capacity and bipositional installation SIE050N Aparici

Product description:

• Electric boiler with a capacity of 50 litres.
• It can be installed both vertically and horizontally.
• It has temperature memory.
• It has a double sheathed ceramic heating element, ideal for areas with hard water, providing high protection.
• The inner boiler is made of 2 mm thick cold-rolled carbon steel with a vitrified enamel coating baked at 860ºC, 220µ thick, which provides adequate protection against corrosion.
• The device incorporates a magnesium anode (Ø20x300mm) which acts as additional protection.
• A pilot light located on the front of the register cover indicates the operation of the heating element.
• Made of 2 mm thick carbon steel.
  • Vitrified enamel boiler coating 220µ thick.
  • Cylinder outer body made of 0.4 mm thick carbon steel.
  • Cylinder outer body finished in 70µ white epoxy-polyester paint.
  • Upper and lower outer body cover made of 2.5 mm thick ABS.
  • CFC-free expanded polyurethane insulation, 20 mm thick.
• Two anchoring legs attached directly to the boiler.
• Safety valve set at 10 bar supplied with the appliance.
• The boiler measures 380 mm in diameter, 395 mm in depth and 748 mm in height.
• Weighs 18.95 kg.
• Screws and plugs included.

Technical data:

• DHW production system: Accumulation.
• Energy source: electric.
• Energy efficiency: C.
• Electrical power: 2000 W (1000w+1000W, selectable from the front).
• Heating time at 50ºC: 84 min.
• Maximum pressure: 9 bar.
• Rated voltage: 230 V.
• Rated frequency: 50/60 Hz.
• Connection type: 1/2".
• Voltage/Frequency: 220-240 V 50/60 Hz.
• Maximum current: 8.7 A.
• Shielded resistance under enamelled sheath of 7 W/cm2.
• Electrical insulation: Class I.
• Protection index: IP24.
• External thermostat bulb regulation: 75 ºC.
• Double safety thermostat: 105ºC.