Silent bearing puller kit for BMW Vida XL

Product description:

• This is a set of tools delivered in a container box.
• It is useful for removal and installation:
  • Ball joints.
  • Axle shafts.
  • Bearings.
• Including:
  • 1 225 mm feed rod to drive silent bearing inserts with 1.5 mm long M12 thread with 8 mm drive hex key.
  • 1 movement thread on the shaft and roller bearing in the pressure piece which causes a high train and pressure performance with minimum effort (torque).
  • 1 shaft nut with 1.5 mm M12 thread, with 19 mm hexagonal drive key.
  • 1 compression nut with roller bearing, 1.5 mm M12 internal thread, with 24 mm hexagon spanner.
  • Training and retraction pressure diagrams for removing and inserting the ball joints at the rear of the rear wheel carrier.
  • 1 support sleeve, outer diameter 70 mm, inner diameter 57.5 mm, lateral grooves.
  • 1 support plate, 12.5 mm bore diameter, 70 mm outer diameter, cut out with 57 mm outer diameter and 12.2 mm height.
  • 1 pressure extraction sleeve, with 1.5 mm M12 internal thread, 51 mm outside diameter, 49.7 mm inside diameter and 35.2 mm height.
  • 1 Intake pressure sleeve, with 1.5 mm M12 internal thread, outside diameter 58 mm, inside diameter 47 mm and a height of 43.1 mm.
  • Training and retraction devices for removing and inserting the ball joint and the rubber support on the rear arm
  • 1 Removable spacer sleeve with a bore diameter of 12.5 mm, outer diameter of 55 mm, inner diameter of 46 mm and a height of 72.3 mm.
  • 1 Pull-out sleeve, with a bore diameter of 12.5 mm, outside diameter of 45 mm, inside diameter of 36 mm and a height of 30.1 mm.
  • 1 Intake spacer sleeve, with 1.5 mm M12 internal thread, 55.1 mm outside diameter, 46.5 mm inside diameter, 30.1 mm height, with side phase.
  • Training and retraction pressure diagrams for removing and inserting the rubber support on the rear axle downwards, rear gear screw.
  • 1 Spacer sleeve, with a bore diameter of 12.5 mm, an outer diameter of 58 mm, an inner diameter of 47 mm and a height of 60.5 mm.
  • 1 Pressure element, with 1.5 mm M12 internal thread, 49.9 mm outside diameter, 32.0 mm inside diameter and 25.3 mm height.
  • Training and retraction pressure diagrams for removing and inserting the rubber mounts on the rear, front and rear drive bracket.
  • 1 Sleeve with an inside diameter of 12.5 mm, outside diameter of 65.0 mm, inside diameter of 50.3 mm and a height of 70.1 mm.
  • 1 pressure extraction piece, with 1.5 mm M12 internal thread, 48.0 mm outside diameter, 32.0 mm inside diameter and 20.1 mm height.
  • 1 Intake pressure piece, with 1.5 mm M12 internal thread, outside diameter 65.0 mm, inside diameter 32.0 mm and a height of 20.3 mm.
  • 1 Perforated plate, with a hole diameter of 12.5 mm, outside diameter of 50.2 mm, cut out with an outside diameter of 46.0 mm and a height of 12.1 mm.
• Applicable for BMW vehicles series 1 to 8.