Main risks

• Risk of electric shock from splashes, condensation or damaged cables.
• Overheating or failure if the unit runs dry or is obstructed.
• Accidental suction of fry, small invertebrates or plant debris.
• Excessive currents that may stress fish and corals or lift the substrate.
• Pinching or crush injuries from powerful magnets during installation.
• Wavemaker falling due to poor attachment, with possible damage to the tank glass or the unit.
• Noise and vibrations that may alter animal behaviour.
• Splashes and salt build-up that may damage furniture, sockets and nearby accessories.

Safe use

• Install the wavemaker with the mounting specified by the manufacturer and check it is secure before letting go.
• Aim the flow to avoid direct jets at fish, corals, heaters or sensors; start on low power and adjust gradually.
• Ensure the intake grille or guard is correctly fitted, especially if there are fry or invertebrates.
• Always disconnect from the mains before putting your hands in the aquarium or moving the device.
• Keep a drip loop in the cable and keep electrical connections in a dry place; water must not run down into the plug or socket.
• Do not operate the unit out of water if it is designed for submersible use, or with the inlet/outlet blocked.
• Avoid placing it too close to the surface if it causes splashing or draws in air.
• Use only compatible accessories and controllers recommended by the manufacturer.

Storage and maintenance

• Periodically clean grilles, rotor and impeller to remove algae, limescale and sediment; rinse well before reuse.
• Frequently check the cable, housing, magnet/suction cups and mounts; replace any parts that are worn, cracked or corroded.
• Switch off and wait for the rotor to come to a complete stop before removing the unit from the water.
• Keep the power supply and controllers dry; clean them with a slightly damp cloth and never immerse them.
• Monitor and remove salt build-up around the aquarium to prevent drips towards sockets or extension leads.
• When storing, dry the unit completely and place it in a cool, dry location; keep magnets away from sensitive items.
• Check the flow after each cleaning or any change in decoration/stocking and readjust if necessary.

Restrictions of use

• Product for use in indoor aquariums; do not use outdoors without specific protection.
• Not a toy; installation and handling by adults only. Keep out of reach of children and pets.
• Do not use with very small animals without an appropriate intake guard.
• Do not operate if the cable, plug, housing, mount or magnet shows damage.
• Do not cover water inlets or outlets or modify the device.
• Do not direct the flow continuously at the substrate in aquariums with fine sand or at species sensitive to strong currents.
• Do not use the unit with liquids other than aquarium water or during the application of concentrated chemicals.