Main risks

• Slips on wet floors due to splashes, leaks or overflows.
• Cuts or injuries from contact with edges or broken ceramic parts.
• Injuries from detachment if the urinal is poorly anchored or mishandled.
• Odours and backflow of gases if the trap or sealing system fails (in waterless models).
• Skin and eye irritation or harmful fumes due to incorrect use or mixing of cleaning products.
• Blockages that may cause overflows and water damage.
• Electrical hazard if the model includes a powered sensor or valve and moisture enters electrical components.
• Deterioration or cracking due to thermal shock when pouring very hot liquids.

Safe use

• Carry out installation with appropriate fixings and connections, following the manufacturer’s instructions; if you are not experienced, use qualified personnel.
• Check the drainage for leaks and correct operation before commissioning and after any intervention.
• Do not hang from, sit on or place body weight on it; avoid impacts with hard objects.
• Keep the floor dry: remove spills immediately and, in traffic areas, signpost wet surfaces.
• Do not dispose of chewing gum, wipes, cigarette butts, thick paper or objects; use bins for waste.
• Use cleaners compatible with sanitary surfaces; do not mix bleach with ammonia or with acids/descalers.
• During cleaning, wear gloves and, if there is a risk of splashes, eye protection; ensure bathroom ventilation.
• If it includes a sensor or electrical supply, disconnect the power before cleaning or handling and protect the components from moisture.
• In waterless models, maintain the sealing system or cartridge as per the manufacturer’s instructions to prevent bad odours and gas backflow.

Storage and maintenance

• Before installation, store the product in its packaging, in a dry, stable place protected from impacts; do not stack it in an unstable manner.
• Transport and handle with care: the ceramic may chip or break.
• Periodically check fixings, seals, diffusers and trap/seal; replace worn, loose or corroded parts.
• Remove limescale from valves and diffusers with compatible products; rinse and dry to avoid slippery residues.
• Address drips and leaks immediately; if necessary, shut off the water supply until it has been repaired.
• Unblock using appropriate tools; avoid extremely corrosive products that could damage the enamel or the installation.
• Keep the area beneath clear and clean to prevent water accumulation and facilitate hygiene.

Restrictions of use

• For sanitary use exclusively for urination; do not pour oils, paints, solvents, greases or very hot liquids.
• Do not use as a seat, step or support point.
• Do not use if it shows cracks, loose fixings or loose parts; remove from service until repaired.
• Young children must use it under adult supervision and at an appropriate height.
• Do not tamper with or modify flush valves, sensors or cartridges; use only compatible spare parts.
• Avoid installing on partitions or surfaces that cannot bear the load without adequate reinforcement.