Main risks

• Burns from water that is too hot or sudden temperature changes when starting the shower.
• Falls caused by wet floors or splashes outside the shower area.
• Injuries from the shower head or arm coming loose if not securely fixed.
• Damage from leaks caused by improperly seated washers or damaged threads.
• Discomfort or eye irritation from misdirected spray due to limescale build-up or dirt.
• Risk of bacterial growth in stagnant water after long periods without use.
• Minor knocks or cuts when handling tools during installation.

Safe use

• Before installing or replacing, check compatibility with your system (connection type and typical operating pressure).
• Shut off the water supply and protect the work area. Hand-tighten first, then finish with a tool only as needed, without forcing.
• Fit the washer correctly and, if the connection requires it, use suitable sealing material. Avoid over-tightening.
• After installation, turn the water on gradually, flush for a few seconds and check for leaks. Aim the spray towards the shower tray.
• During use, check the temperature with your hand before standing under the shower head, especially with children or people sensitive to heat.
• Do not hang from or use the shower head or arm for support. Adjust the direction with gentle movements, without over-rotating.
• Avoid directing the spray towards light fittings, sockets or other electrical equipment.

Storage and maintenance

• If you are not going to install it immediately, store the shower head in a dry place, protected from dust, impacts and prolonged exposure to sunlight or heat.
• Clean regularly with a soft cloth and pH-neutral soap. Avoid scouring pads, solvents, bleach and abrasive products.
• Remove limescale periodically in line with your water hardness; use suitable descalers and rinse thoroughly before using again.
• Check washers, filters and joints if fitted; replace any worn or cracked parts.
• If it has not been used for a while, let the water run for a few seconds before showering to flush out any water left inside.
• If you notice persistent leaks, unusual noises or vibrations, stop using it and check the installation to prevent water damage.

Usage restrictions

• Intended for indoor domestic showers. Do not install outdoors or in steam environments unless specified by the manufacturer.
• Do not exceed the system pressure or temperature recommended by your system’s manufacturer.
• Do not modify the product (drilling, filing, removing internal components) or mix incompatible parts.
• Do not use with water containing sand or solids without proper filtration, to avoid blockages and irregular spray.
• Keep small parts and washers out of the reach of children. Children and people with reduced mobility or thermal sensitivity should use it under supervision.
• Do not use pressure washers directly on the installed shower head.