Main risks

• Electrocution due to damaged, wet or poorly connected cables, plugs or terminals.
• Overheating and fire from overloading unsuitable extension leads, adaptors or extension blocks.
• Serious risk of backfeeding into the mains if generators are connected without an appropriate transfer switch.
• Fire and burns when handling fuel (spills, flammable vapours and sparks).
• Burns from contact with accessories near the exhaust or engine (pipes, heat shields, silencers).
• Entrapment, cuts or impacts during the installation of wheel kits, frames or mounts.
• Damage to the generator or connected equipment due to incompatibility of voltage, current, plug type or polarity.

Safe use

• Verify the accessory’s compatibility with your generator (connector type, voltage, current and permissible power) before use.
• Visually inspect cables, plugs, sockets and enclosures; do not use the accessory if you see cracks, exposed conductors, heat discolouration or looseness.
• Connect and disconnect with the generator switched off and unloaded; wait for components near the exhaust to cool before touching them.
• Use outdoor-rated extension leads of suitable cross-section and length; fully unwind them and keep connections raised and dry.
• Do not modify plugs or make improvised splices; use adaptors and distribution units designed for use with generators.
• Distribute loads and observe the accessory’s maximum current rating; use overcurrent and residual-current protection where appropriate.
• For transfer switches, wall sockets or fixed connections, use a qualified electrician for installation and testing.
• When handling fuel, use suitable containers, ventilate the area, switch off the generator and avoid flames or sparks; clean up any spill immediately.

Storage and maintenance

• Store accessories in a dry, clean, ventilated place, away from moisture, dust and direct sunlight.
• Protect plugs and connectors with caps or covers; prevent them from getting dirty or wet.
• Coil cables without kinks or knots, do not place weight on them, and secure them with soft ties.
• Periodically check the condition of insulation, contacts, fasteners and enclosures; immediately replace any damaged part with compatible spares.
• Clean with a dry cloth; do not use aggressive solvents or high-pressure water on electrical connections.
• If the accessory includes a battery or charger, observe polarity, avoid short circuits and store it in a cool place; carry out maintenance charging as indicated by the manufacturer.
• If using covers or enclosures, ensure they are clean and dry to prevent condensation and corrosion.
• Store fuel in suitable, tightly closed containers, in ventilated areas and away from heat sources and direct light.

Usage restrictions

• Do not exceed the accessory’s rated current or power, and do not use coiled cables under load.
• Do not use electrical connections outdoors without protection against rain or splashes; never immerse cables or plugs.
• Do not connect the generator to the household installation without a transfer switch installed by qualified personnel; avoid backfeeding via plugs.
• Do not daisy-chain adaptors or multi-way units that may cause loose connections or overheating.
• Do not cover the generator’s air inlets or outlets with covers or enclosures during operation, nor duct the exhaust into enclosed spaces.
• Do not handle moving or hot parts without suitable gloves and without first allowing sufficient cooling time.
• Do not allow use by children; supervise inexperienced persons during installation or operation.
• Do not use accessories for lifting or moving unless they are intended for that purpose; use wheel kits on firm, level surfaces.