Main risks

• Leaks from poorly fitted connections that may cause slips, water damage or wastage.
• Sudden disconnection due to high pressure with possible hose whip and impact injuries.
• Minor burns if used with hot water or if water becomes overheated by the sun in the hose.
• Pinches or minor cuts when handling quick connectors or threads.
• Deterioration from frost or prolonged exposure to the sun (UV), with a risk of cracks and breakage.
• Contamination of drinking water by backflow or by residues of chemicals in the hose.
• Electrical hazard when using water near sockets, cables or electrical equipment.
• Thread and diameter incompatibility that may damage the tap or connector and cause leaks.

Safe use

• Check size and connection type compatibility before installation.
• Turn off the water supply and relieve pressure before attaching or detaching any connector.
• Screw and fit by hand, without forcing or overtightening; avoid tools that could damage the threads.
• Check the condition and correct placement of seals and O-rings; replace any that are worn or damaged.
• Turn the water on gradually after installation and check for leaks; rectify them before putting it into service.
• Do not pull the hose by the connector; hold the connector body to prevent breakage.
• Avoid twists and kinks near the connection point; use guides or supports if necessary.
• Do not leave the system pressurised and unattended for long periods.
• Keep the spray and connections away from sockets and electrical appliances.
• Use only with cold or lukewarm water unless expressly specified by the manufacturer.
• If using fertilisers or other products, rinse the hose and connectors thoroughly after each use.
• If connecting to drinking water outlets, prevent backflow of contaminated water by using suitable backflow prevention devices in line with the system manufacturer's recommendations.

Storage and maintenance

• Disconnect and drain the water after use to avoid residual pressure and bad odours.
• In winter, empty and store under cover to prevent frost damage.
• Store in the shade, away from direct heat and prolonged sunlight.
• Clean sand and dirt from threads and shut-off mechanisms to maintain a proper seal.
• Check regularly for cracks, wear, corrosion and looseness; replace damaged parts.
• Lightly lubricate the seals with a water-safe silicone product if permitted by the manufacturer.
• Avoid oils, solvents or harsh detergents that may degrade plastics and seals.
• After periods of inactivity, check and hand-tighten the connections and make sure there are no leaks.

Restrictions on use

• Not a toy; keep out of reach of young children.
• Do not use with gas, fuels, solvents or liquids other than water.
• Do not use with very hot water or steam unless specifically indicated by the manufacturer.
• Do not use with pressure washers or other high-pressure equipment if the connector is not rated for it.
• Do not drink water that has passed through the hose or connectors unless the assembly is expressly rated for drinking water.
• Do not use connectors that are cracked, deformed or have damaged seals.
• Use by minors or persons with limited dexterity should be supervised.
• Do not modify, drill or sand the connectors; use only the accessories provided by the manufacturer.