Main risks

• Irritation of skin, eyes and respiratory tract from direct contact or vapours.
• Accidental bonding of skin and fingers, especially with fast-curing adhesives.
• Burns from hot-applied adhesives or from heat-generating reactions when mixing components.
• Risk of fire or explosion with solvent-containing products or pressurised containers, near flames or sparks.
• Splashes when opening containers, cartridges or aerosols due to internal pressure.
• Damage, discolouration or swelling to sensitive materials (plastics, paints, fabrics) due to solvents.
• Slippery surfaces or unwanted bonding caused by drips and spills.
• Strong odours and build-up of vapours in poorly ventilated spaces.

Safe use

• Read and follow the specific instructions for each product, including mixing ratios and curing times where applicable.
• Work in well-ventilated areas and avoid inhaling vapours; use protective gloves and goggles to prevent contact.
• Keep away from flames, sparks and hot surfaces; do not smoke during application.
• Ensure surfaces are clean and dry; apply only the necessary amount to avoid excess and drips.
• For two-part adhesives, mix only the amount needed and never in closed containers.
• If it sticks to the skin, do not pull sharply; soften with warm soapy water or oil and separate carefully.
• Open cartridges and aerosols with the nozzle pointing away from the face and test on an inconspicuous area.
• Do not dilute or mix with other products or solvents unless expressly directed by the manufacturer.
• Avoid accelerating drying with direct heat unless the product recommends it.
• Clean any excess immediately using the method recommended by the manufacturer and close caps and nozzles tightly after each use.

Storage and maintenance

• Keep in its original, tightly closed container, in a cool, dry and well-ventilated place, protected from sunlight and away from heat sources.
• Keep out of reach of children and pets; store upright where possible to prevent leaks.
• Avoid extreme temperatures; do not freeze or leave inside vehicles exposed to heat.
• Store separately from food and drink.
• For aerosols and pressurised cartridges, do not pierce or incinerate, even when they appear empty.
• Clean nozzles and threads after each use to prevent blockages; if they become blocked, do not force with sharp objects.
• Check the condition of the product; if it shows unusual changes in odour, colour or texture, do not use it and dispose of it safely without pouring it down the drain.

Restrictions of use

• Intended for adult use; keep out of reach of children and use only with direct supervision if they are involved in crafts.
• Do not apply to skin, nails, eyelashes, mucous membranes or dental prostheses; do not use on items that will come into contact with food or the body unless clearly indicated by the product.
• Do not use in spaces without adequate ventilation or near flames, sparks or hot appliances.
• Do not apply to electrical equipment while it is connected to power, and do not handle the bonded area until the adhesive has fully cured.
• Do not use for structural fixings, safety-critical components or critical loads unless the product explicitly specifies this.
• People with asthma, skin allergies or sensitivity to solvents should minimise exposure and choose low-odour options where possible.
• Do not use as a permanent seal in aquariums, drinking-water systems or on items that will be heated in a microwave or oven, unless specifically indicated by the product.