Main risks

• Electric shock from damaged equipment, wet sockets or improper connections.
• Water ingress into non-sealed luminaires or those with deteriorated seals, potentially causing failure and short circuit.
• Overheating or burns if underwater lights are switched on out of water or become covered by mud or leaves.
• Housing or glass breakage with a risk of cuts.
• Trips or snags caused by cable runs around the pond.
• Glare and disruption of the light cycle of fish and plants due to excessive night-time lighting.
• Fire risk from makeshift joints or poorly located, unventilated transformers.

Safe use

• Check that the product is suitable for outdoor use and, if used underwater, specifically rated for immersion.
• Disconnect the power before installing, moving or cleaning; always handle with dry hands.
• Use only compatible transformers, power supplies and connectors that are suitable for outdoor use; position electrical equipment in a dry, raised area protected from splashes.
• Connect to a point with residual current device (RCD) protection where applicable.
• Route and secure cables along safe paths, free from strain or pinching, away from sharp edges, pumps, filters and garden tools.
• Aim spotlights to avoid direct glare and reflections; use timers to respect the pond's day/night cycle.
• Do not switch on submersible luminaires out of water, and allow them to cool before touching.
• Do not drill or open housings, or make DIY joints; use sealed accessories from the manufacturer when required.

Storage and maintenance

• Isolate the power before any maintenance and wait for surfaces to cool.
• Periodically clean algae and limescale with a soft cloth or soft brush; avoid abrasive or corrosive products.
• Check cables, connectors and seals for cracks, hardening or corrosion; replace damaged parts without attempting makeshift repairs.
• Watch for moisture or condensation inside the luminaire; at any sign of water ingress, remove the unit and check the seals before using it again.
• Replace bulbs or modules only if permitted by the manufacturer and with compatible spares.
• Keep transformers and junction boxes in ventilated, dry locations that are accessible for inspection.
• If removed seasonally, dry the units thoroughly and store them indoors, with no weight on the cables and protected from frost and direct sunlight.

Restrictions on use

• Do not use in swimming pools, spas or bathing areas unless expressly stated by the product.
• Do not use extension leads, power strips or sockets that are not suitable for outdoor use.
• Do not stare at LEDs or high-intensity spotlights at close range.
• Do not use the equipment if there is visible damage, a burning smell, sparking, or repeated tripping of the RCD.
• Keep out of reach of children and pets; do not allow them to handle cables, transformers or lights.
• Do not cover luminaires with stones, soil, leaves or decorations that impede heat dissipation.
• For fixed installations, buried cabling or integration with the garden's electrical network, it may be advisable to use a qualified installer.