Main risks

• Cuts from glass panel breakage due to impacts, point loads or sudden temperature changes.
• Finger entrapment in sliding doors, hinges or magnetic seals.
• Slips and falls caused by water and soap inside the enclosure and on the surrounding floor.
• Leaks and pooling due to worn seals or a blocked drain.
• Knocks against edges or profiles, especially if the door becomes misaligned.
• Difficulty exiting if the doors jam due to dirt or misalignment.
• Scalds from excessively hot water when starting the shower.
• Panels falling or toppling during installation or improper handling.

Safe use

• Check stability and secure fixings before first use and periodically.
• Open and close the doors gently using the handles; keep fingers clear of tracks, rollers and closing seals.
• Do not force jammed doors: clean the tracks and check the stops and rollers before using again.
• Check the water temperature before entering and avoid applying very hot water suddenly to cold panels.
• Use a non-slip mat if the tray is slippery and dry any water on the surrounding floor immediately.
• Keep the drain free of debris to prevent pooling and overflows.
• Do not hang towels or heavy objects from the doors or frame of the enclosure.
• Follow the manufacturer’s installation instructions; if unsure or handling heavy panels, use a qualified installer.

Storage and maintenance

• Before installation, store the panels vertically on a stable surface with protection; avoid impacts and areas of foot traffic.
• Do not place weight on the glass or tray; keep the packaging until installation.
• Clean with warm water and mild pH-neutral soap; rinse and dry after use to reduce limescale and slippery surfaces.
• Avoid abrasive scourers and very harsh products, chlorinated agents or concentrated acids that may damage glass, seals and finishes.
• Clean tracks and profiles regularly to remove grit or build-up that hinders sliding.
• Inspect seals, sealant and brush strips; replace worn or loose components to maintain watertightness.
• Gently tighten accessible screws if they loosen, without over-tightening; if play persists, stop using the enclosure until corrected.
• Ventilate the bathroom after each use to promote drying and reduce mould growth.

Restrictions of use

• Do not use the enclosure if there are cracks, chips, significant play or loose parts; do not use it until repaired or replaced.
• Do not stand, sit or lean your body weight on profiles, bars, shelves or doors.
• Do not strike or slam; avoid impacts with hard objects.
• Do not modify the structure or drill profiles or panels to add accessories not intended.
• Do not use electrical appliances inside the enclosure or with wet hands.
• Do not use solvents, flammable aerosols or incompatible cleaners inside.
• Children, elderly people or those with reduced mobility should use it with supervision or appropriate aids.
• Do not leave doors open obstructing walkways where there is a risk of tripping.