

Roll over image to zoom in


Power and harmonics meter with graphic LCD display PCE-PA 8300 PCE Instruments
PCE Instruments - PCE-PA 8300-1
New product
Description and specifications
- This is a wattmeter, harmonics and energy meter.
- It is used to measure:
- Three-phase mains power and quality.
- Three-phase mains power and quality.
- Apparent, active and reactive power.
- Power factor.
- It has a graphic display.
- Measures up to 9999 MW.
- Includes:
- Wattmeter.
- 3 Current clamps.
- 4 Insulated alligator clips.
- 4 Safety test leads.
- 8 AA 1.5 V batteries.
- 1 9 V mains adapter.
- 1 Carrying case.
- 1 2 GB SD memory card.
- Instructions for use.
Technical data:
- The display is a 3.7" LCD (320 x 240 pixels) and is backlit.
- The device complies with IEC1010CAT III 600 V safety standard.
- The AC V input impedance is 10 MOhm.
- Operating frequency of the current clamps is 40 Hz to 1 kHz.
- Operating frequency of tested current clamps is 45 to 65 Hz.
- Overload protection:
- AC V: 720 V RMS.
- AC A: 1300 A with current clamps.
- The memory is SD.
- Logging interval is 1 second and logging is real time.
- The recording rate is from 2 to 7200 seconds.
- Data output is via USB or RS-232 cable.
- The operating temperature is 0 to 50° C.
- The permissible ambient humidity is < 80 % R.H..
- Power supply is via 8 x 1.5 V AA batteries or 9 V mains adapter.
- The power consumption of the meter is 300 mA DC, while that of the current clamps is 34 mA DC.
- The maximum permissible cable diameter is 50 mm.
- The device is 12.5 cm wide, 22.5 cm high and 6.4 cm deep.
- The clamps are 6.4 cm wide, 21 cm high and 33 cm deep.
- The clamp measures 8.6 cm.
- The meter without batteries weighs approximately 950 grams.
- The current clamps weigh 467 grams.
Optional:
- Model PCE-PA 8300-2.